Ashtech 19/11/2010 Page 2 of 6
1. What is the processor speed?
ProMark 100 / ProMark 200 is using the Marvell PXA 320 processor always running at 806MHz
speed. Frequency of the external data/program bus on DDR is 130 MHz for 32 bits width.
2. What is the memory capacity?
ProMark 100 / ProMark 200 has 256 MB of DDR RAM and 2GB of flash memory (iNAND). The
internal memory size available for data storage is about 1.9 GB. In addition SD High Capacity
(SDHC) memory cards are supported. Although SDHC technology doesn’t imply any limitation in
terms of supported card size, Ashtech has tested and validated memory cards up to 32 GB; cards
from several manufacturers have been tested: Sandisk, Kingston, Dane-Elec, PNY, Hama.
3. How can I use the receiver Suspend mode?
Microsoft Windows Mobile operating system includes a battery saving mode called “Suspend
mode”. On ProMark 100 / ProMark 200 this mode can be activated through a short press on
On/Off button (less than 5 sec.). As the “Suspend mode” is switching off all GNSS and GSM
capabilities, Ashtech does not recommend entering into this mode during a surveying session.
Also, be aware not to program automatic switch to suspend mode option as it could happen even
when the receiver is used e.g. for raw data recording.
4. How can I make a reset of the device?
If a use reset is needed (e.g. freeze of an application, impossible to operate the unit, or any other
unusual unit behavior), it is recommended to perform one of the reset actions below:
- use Reset GNSS option in GNSS Toolbox application (Cold Reset – INI command)
- pressing simultaneously ESC, IN and OK buttons (reboots the unit)
- (if none of the above is working) remove and replace the unit battery
5. Is it possible to start the receiver in the docking station?
Yes, but only if the receiver battery is placed inside the receiver.
6. How long will it take to charge the battery?
It will require less than 3 hours for an empty battery to be charged in the docking station whether
it is in the receiver or in the spare battery slot. When both receiver with a battery and a spare
battery are in the docking station, the battery in the receiver will be charged first.
7. What can I do if the receiver is not starting?
It is not possible to switch on the receiver if no battery is present inside the battery compartment.
This is also the case if the receiver is placed in the docking station (this is to prevent a user to start
operation while in the docking station and lose information when taking out without a proper unit
switch off.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais